Operation Manual

OPERATION
Picture5
Picture 6
1
 Insertthepluginthewalloutlet,theunitwillproduce3beepingsounds.
2
Press the
-button to switch the device on, the louver will open (D516 - D 520).
When
in auto mode, the adjustment button
isusedtosetthedesiredhumiditylevel.The
hydrostatisadjustablefrom40%to80%.
Thevalueincreasesby5%eachtimeyoupressthebutton.Thedisplayindicatesthe
sethumidity(SETHUMIDITY)andalsotherelativehumidity(ROOMHUMIDITY).
D516 - D 520
Thedevicewillshowablueindicatinglightaroundthecontrolpaneltoshowtotheuser
that the device is working.
Theblueindicatinglightcanbeswitched“off”or“on”bypressingthe
and at the
sametime.Thiswillnotinfluencethedehumidificationperformanceofthedevice.
3
 Ensurethatthewatercontainerhasbeenpositionedcorrectly.Ifthe -light switches
onwhenyouusethedeviceforthefirsttime,removethewatercontainerfromthe
device and replace it in the correct position.
Wheninautomode,thedevicestartstodehumidifywhentherelativehumidityinthe
room is higher than the set value.
Thedeviceswitchesoffautomaticallywhenthesetvalueisreached(fanwillcontinuein
lowspeed),andrestartswhenthehumidityintheroomrisesagain.
G
NOTE!
• Forextraprotectionofthecompressorthedehumidifierisprogrammedsuch
thatthecompressorcanonlyrestartwhenmorethan3minuteshavepast
since compressor has switched off.
• Tooptimisethedehumidificationefficiencyandtopreventpossible
decolouring:alwaysplacedehumidifierawayfromdirectsunlight.
4
87
D 516 - D 520
D 510 - D 512