Operation Manual

50
4
TROUBLESHOOTING
Checkthefollowingbeforecontactingtechnicalsupport:
Problem Cause Solution
Light4onthedisplayis
blinking
Dirtyfilters
Replacethefilterpackage(4x)
andresetthefilteralarmbypres-
singfor3secondsbutton1on
the control panel or button 4 on
the remote control.
The device does not
work
The back panel has not been
replacedcorrectly.
Removethepanelandputit
back again. Make sure that the
top of the panel is placed cor-
rectly.
The power cord is not connected. Insert the plug into the socket.
The power cord is not connected
properly.
Insert the plug into the socket
correctly.
The fuse of the unit is defective.
Havethefusereplacedbya
recognised Zibro dealer.
The remote control is
not working.
The batteries in the remote con-
trol are dead.
Replacethebatteries.
The device does not
removeodoursand/or
dust.
The filter package has not been
insertedcorrectly.
Insert the filter package cor-
rectly.
Thefilterpackageisdirty. Replacethefilterpackage.
TheAutomodedoesn't
work.
Thesensorisdirty.
Use cotton swabs to clear the
sensor.
No/insufficientaircircu-
lation.
The air flow is blocked.
Removetheblockage.
Replacethefilters.(4x)
50