User's Manual

SHORTCUT OPERATIONS

CTCSS/DCS Scan

Press

key, the top left corner of LCD displays “ ” icon, press key to

enter into CTCSS/DCS scan. Under this state, rotate channel switch to change scan

direction. When scan the matching CTCSS/DCS signaling, it will stay 5seconds and

then go on scanning. Press any other keys except , , key to exit.

NOTE: This function is invalid when transceiver works in professional mode or the

arrow directed channel no setting CTCSS/DCS signaling.

In current channel, if signaling set as CTCSS, it will scan CTCSS, if sets as DCS, will

scan DCS.

Offset Frequency Direction Setup

Under standby state, press key, the top left corner of LCD displays “ ” icon,

press key to choose offset frequency direction. There are 3 options, Positive

offset, Minus offset, shut off offset.

1. (+) Positive offset: Indicates TX frequency is higher than RX frequency. When

enable reverse function, the RX frequency is higher than TX frequency.

2. (-) Minus offset: Indicates TX frequency is lower than RX frequency. When enable

reverse function, the RX frequency is lower than TX frequency.

3. None: Indicates shut offset off.

Under frequency mode (VFO) or channel mode, press

key then press key to choose positive

offset direction(+), minus offset direction (-) , shut offset off one by one (Please refer to offset frequency

setup).

NOTE: This function is unavailable in professional transceiver mode.