User's Manual

03
The transceiver is a high performance amateur transceiver with dual band, dual standby, dual display and other
kinds of functions. According to practical application,you can set the radio operates as Amateur Transceiver
or Professional Transceiver. There are also 3 levels operation menu to set functions as per you need. It is
easy and convenient.
Operation Mode:
1.
By programming software:A. In PC software's "General Setting"menu to
choose "Display Mode" , channel mode works as Professional transceiver
,other two modes as Amateur transceiver.
By manual setup:B. Please refer to "Display Mode" in Page 45.
Amateur Transceiver Mode:
2.
Except setting as CH mode, others considered as Amateur
transceiver mode. Under this mode,press
key to switch between Channel mode
and VFO.
Frequency + Channel mode: A. At this mode, When set display as"FREQ",it
enters into Frequency+Channel mode, new setting of channel operation and
shortcut operation can be temporarily used by user. Once the radio is turned
off or switched to another channel, the temporary setting will be erased and
back to initial settings.(As pic 1)
Channel+Name Tag Mode:B. When set display as "NAME",it enters into
Channel +Name Tag Mode. At this mode, it will display corresponding
channel name when the current channel is edited with name. Otherwise, it
will display frequency + channel. Its operations are the same as frequency +
channel mode. (As pic 2)
OPERATION MODE (AMATEUR TRANSCEIVER OR
PROFESSIONAL TRANSCEIVER)
(
Pic 1
)
(
Pic 2
)
(
Pic 3
)
(
Pic 4
)