User's Manual
24
8
+285Auto power off after 2h
2))Disable Auto power off
Press
4.
TX/DCS
NH\WRFRQ¿UPDQGH[LW'HIDXOW2))
DTMF Transmitting Time
Press and hold
1.
F
U
NC
key for over 2s to enter general setting.
Press
2.
CA
LL
/
SCAN
key to choose No.21
menu, LCD displays "SPD--50".
Turn selector knob to select the desired
3.
setting.
30/50/100/200/300/500, which indicates the time for sending each
DTMF signal & the interval between each DTMF being sent.
Press
4.
TX/DCS
NH\WRFRQ¿UPDQGH[LW'HIDXOW06
Squelch level Setup
Setting the radio to a tight squelch level, you can avoid unwanted
signals or noise, but you may not receive a weak signal. Therefore, it will
be better for you to select the normal squelch level
Press and hold
1.
F
U
NC
key for over 2s to enter general setting menu.
Press
2.
CA
LL
/
SCAN
key to choose No.22
menu, LCD displays "SQL--04".
Turn selector knob to select the desired
3.
squelch level.
OF-20 total 21, OF is min setting value(ON)
Press
4.
TX/DCS
NH\WRFRQ¿UPDQGH[LW'HIDXOW
Scan Dwell Time Setup
There are 3 kinds of Scan Dwell Time for option.
Press and hold
1.
F
U
NC
key for over 2s to enter general setting menu.
Press
2.
CA
LL
/
SCAN
key to choose No.23 menu, LCD displays "SCAN-
-TO".
Turn selector knob to select the desired Scan Dwell Time.
3.
72It pauses 15s once scanning a
matching signal, then resume scan.
&2It pauses once scanning a matching
signal, signal disappeared then resume
scan.
6(It stops once scanning a matching
signal.
Press
4.
TX/DCS
NH\WRFRQ¿UPWKHVHOHFWLRQ
and exit.Default:TO.
LCD Backlight
Press and hold
1.
F
U
NC
key for over 2s to
enter general setting menu.
Press
2.
CA
LL
/
SCAN
key to choose No.24
menu, LCD displays "LAMP--25".
General Setting
Press
SCAN
, then turn selector knob also can select the desired
squelch level.
If the transceiver has set at higher squelch level, it may fail to hear
the calling. If set at lower squelch level, the radio will be interfered.