User Manual

19
General Setting
the frequency step size changes to 1Mhz, in channel mode,
adjust selector knob will jump 10 channels.
Right
long press: Talk Around. When this function is
activated, transceiver can not communicate with repeater.
Repeat the operation to turn off Talk Around.
Right
short press: Frequency reverse function, when
current channel is setup with offset direction and offset
frequency, press this key will turn on frequency reverse
function.The signaling will also be reversed if CTCSS/DCS
signaling existed in this channel. Repeat the short press it
will turn off Frequency reverse function.
Right
long press: In stand by, hold this key until the
LCD displays
, means the compander function is on,
repeater above operation to turn off compander function.
Right
short press: In standby, press this key to set the
CTCSS/DCS code for current channel.
When the LCD displays ENC, the current channel is with
CTCSS encode function.
When the LCD displays ENC and DEC, the current channel
is with CTCSS /DCS code function.
When the LCD displays DCS and DCS icon, the current
channel is with CTCSS code function.
When the LCD displays OFF, the current channel is without
CTCSS /DCS function.
Right
long press: In standby, long press this key to
enter CTCSS/DCS scan, when nd matching CTCSS/DCS
signal, the scan will pause in the way following Scan Dwell
time.The scan direction can be changed by corresponding
channel selector knob. Note:To enable this function, the
channel shall be set up with CTCSS/DCS decode.
7
3.
4.
5.
6.
7.
Press
1.
key to enter function menu.
Turn the Main band selector knob to choose No.21 menu. The LCD
2.
displays "LOCK".
Press the Main band selector knob to
3.
enter function setup.
Switch the Main band selector knob to choose wanted mode.
4.
ON: The keypad lockout function is turn
on, all keys beside
and band switch
knobare invalid.
OFF: The keypad lockout function is turn off.
Press the Main band selector knob or
5.
key to store value and
back to function menu. Press key or hold selector knob for over
0.5 second to store setup and exit.
KEYPAD LOCKOUT
Right short press, shot press this key, the sub band will
display "MAIN" and ashes.In this case, you can setup for sub
band without switch between Main band and Sub band.
Right
long press, choose scrambler group for Main band.
In standby, hold this key, the LCD displays SCR X and
icon. X stands for the group number, repeater above operation
to choose wanted group.
8.
9.