User's Manual
Table Of Contents
46
FUNCTION MENU SETUP
Battery Save Setup
You can set a battery save ratio according to your requirements. The standby time can be extended if
you enable the battery save function, but if you set the ratio setting too high, it may cause you to miss the
beginning of a transmission. When the transceiver receives a matching signal or make start an operation
it will automatically exit this function.
1. Press key, the top left corner of LCD displays " " icon, then press
key enter into function menu.
2. Press
/ key to choose NO.33(OBLTR-8R)/NO.48(TERMN-8R) function
item, it shows "SAVE" on LCD.
3. Rotate channel selector knob to choose desired setup.
OFF: Battery Save is disabled.
1:2: The standby time between normal working state and battery saving mode
is 1:2
1:3: The standby time between normal working state and battery saving mode is 1:3
1:5: The standby time between normal working state and battery saving mode is 1:5
1:8: The standby time between normal working state and battery saving mode is 1:8
AUTO: Battery save ratio is adjusting automatically.
4. Press
key or key to conrm and exit.