User's Manual

19
SHORTCUT OPERATIONS
Add/Cancel Optional signal decode function
NOTE: When this function is on, the user must setup the SIGNAL menu to use the TONE option, then
DTMF/5TONE/2TONE/MSK can be used (For decoding). The programming software is required to set the
tones needed if you require specific optional signaling.
When in standby, press
key, the top left corner of LCD displays " " icon,
press key.
The LCD displays
1. "DTMF" and "
T
" icon, DTMF signaling has been added in the current channel.
Repeat the above operation, the LCD displays 2. "5TONE" and "
T
" icon, the 5TONE signaling has been
added in current channel.
Repeat the above operation, the LCD displays 3. "2TONE" and "
T
" icon, the 2TONE signaling has been
added in the current channel.
(TERMN-8R ONLY) Repeat the above operation, the LCD displays 4. "MSK" and "
T
" icon, MSK signaling
has been added in the current channel.
Repeat the above operation, the LCD displays 5. "OFF", the "
T
" icon disappears, and no optional signaling
has been added in current channel.