User's Manual

33
Use optional CP51 cloning cable, connect the cable between the data jacks on both master and slave.
1.
Press and hold right band
2.
key, then hold this key until the LCD displays "CLONE".
Hold the Main band
3.
key. the Master unit and Slave unit both display "CLONE XX", "XX" stands for the data amount being cloned, when the
Master unit displays "CLONE" again, the Slave unit repower on, means the come completed. Turn off the Slave unit, and change another slave
unit. then repeat step 3 to clone next radio.
9
Cable Clone
This feature will copy the programmed data and parameters in the master unit to slave units. It copies the parameters and memory program settings.
When the Master unit enter clone mode, repeater step 3 will able to clone multi radios.
If the data is not successfully transmitted, turn off both units, make sure the cable connection is correct and repeat the entire operation from the beginning.
9
Clone Cable (CP-51)
NOTE
RESUME FACTORY DEFAULT
If your radio seems to be malfunctioning becuase of wrong operation or setup, this function will able to resume all setup and channels to factory default.
Hold the right band
while power on the radio, all channnel and function setup will resume to factory default.