User's Manual

Programming software starting
(Takes Windows XP system for example)
(picture 1)
(picture 2)
1.Double Click "QPS3318UV_USA setup.exe", then go on installing as
computer command.
2.Click "START" menu of computer, choose "USB To COM" in QPS3318UV_
USA item and click it. Please install USB To Comport drive program as
computer command.
3.Please plug PC03 programming cable into USB port of PC device,
4.Double click "QPS3318UV_USA" shortcut icon, or click QPS3318UV_
USA item in "START" menu to open programming software interface.
5.Choose "COM Port" as computer command, then click "OK" to start
programming software.
NOTE:
should be connected to computer, otherwise the software can not run.
NOTE: In same computer, if programming cable plugs into different USB
port, the COM Port number is different.
situation is happened, please shut down programming software, remove
programming cable from computer, then re-plug cable into computer and
re-start programming software, re-choose COM Port, the programming
will work normally.
then connect to radio.
Before programming, radio should be turned on rstly.
Not turn on or turn off radio when it is connecting with computer,
otherwise it may cause radio not read or write data. If this
The programming software is attached with product identifying system. In first time run, the radio