User's Manual

BASIC OPERATIONS
Emergency Alarm
Under standby state, press and hold [PF1] key which is programmed with ALARM function until LCD
displays "ALARM
Side Key [PF1] function instruction
[PF1] key can be setup in Function Menu 45 for below functions:
VOLT:
1.
Battery capacity inquiry: Under standby, press [PF1] key, LCD displays current battery capacity,
press this key again to exit.
CALL:
2.
Transmit the prestored DTMF/5TONE Encode signal in channel.
FHSS(Version D):
3.
Frequency hopping function. Press [PF1] key, turn on frequency hopping function,
LCD display "FHSS
Note: Receiver and Sender must have same hopping frequency, and must setup MSK decode signalling.
ALARM:
4. Long pressing [PF1] key, LCD display "ALARM
SUBPTT:
5.
Transmit tone pulse frequency:
6.
Press and hold PTT key, then press [PF1] key to transmit selected tone
pulse frequency.
", Emergency alarm function is started. This radio has 4 Alarm modes for optional,
can be setup in programming software. Power off radio to exit Alarm.
", radio will communicate in pre-set hopping frequency range.
", radio will enable the preset alarm function.
Press [PF1] key, radio will transmit on sub-band frequency.