User's Manual

BASIC OPERATIONS

Transmitting

According to [PF2] key setup in programming software, hold [PF2] key to monitor the channel to ensure it

is not busy, press PTT key and talk to speaker.

Please keep the distance between mouth and speaker to be 2.5-5CM, speak in normal tone to get the best

acoustic delity.

Receiving

at the same time, and the arrow icon will ash, you can hear the calling.

NOTE:

is programmed with decode signal, only the same signaling call can be heard.

Squelch off: Press [PF2] key, squelch circuit is not mute, back-ground noise can be heard. Press

[PF2] key again, squelch circuit is mute.

Squelch off Momentary: Press and hold [PF2] key, squelch circuit is not mute, back-ground noise can

be heard. Release [PF2] key, squelch circuit is mute.

NOTE: The above functions are only available after [PF2] key setup in programming software.

NOTE: When press and hold PTT key, transceiver is transmitting if the red LED light is on, release PTT key

to receive calls.

When your radio is called by other party, green or blue LED light will be on, LCD backlight will be on

You may not receive the calling when your radio is set at high squelch level. If current channel