User's Manual

INSTALLING THE BELT CLIP

If necessary, attach the belt clip using the two supplied 3 x 8 mm screws.

Note: If the belt clip is not installed, its mounting location may get hot during continuous transmission

or when left sitting in a hot environment.

◆ Do not use glue which is designed to prevent screw loosening when installing the belt clip, as it

may cause damage to the transceiver.

◆ Acrylic ester, which is contained in these glues, may crack the transceiver's back panel.

INSTALLING THE COVER OVER THE SPEAKER/ MICROPHONE JACKS

If you are not using a speaker/microphone, install the cover over the speaker/microphone

jacks using the supplied 3

6mm screw

Note: To keep the transceiver water resistant, you must cover the speaker/microphone jacks with the

supplied cover.