User's Manual

10
SCAN
Scan is useful for monitoring signals on the transceiver channels. When scanning, the transceiver
checks for a signal on each channel and only stops if a signal is present. The transceiver will remain on
a busy channel until the signal is no longer present. Your dealer programs the delay time between
signal drop-out and Scan resumption. If a signal is received during the delay time, the transceiver will
remain on the same channel.
You can only use Scan if your dealer has programmed at least 2 channels and they are not
locked out of Scan.
To start scanning, momentarily press the key programmed as either Scan or Scan + Temporary
Delete.
● Scanning starts from the current channel and ascends through the channel numbers.
● The LED indicator flashes green.
● When a signal is received on a channel and signaling matches, the LED indicator lights green.
To end Scan, press the Scan or Scan + Temporary Delete key again.
Priority Scan
If enabled, a priority channel is set up one of two ways:
● Your dealer may set up a fixed priority channel on your transceiver.
● You can select your own priority channel, prior to scanning, using the Channel selector.
● Your dealer programs the delay time between signal drop-out and scan resumption.
Temporary Delete
If a key is programmed with the Temporary Delete or Scan + Temporary Delete function, you can
temporarily remove specific channels from the scanning sequence during Scan. When Scan stops at a
channel, you can remove that channel from the scanning sequence by pressing and holding the key
programmed as Temporary Delete or Scan + Temporary Delete for 1 second.
● You cannot delete the Priority channel, if one has been set up.
● You cannot delete a channel if there will be less than 2 channels available for scanning remaining.
● To add the channel back into the Scan list, simply exit Scan mode or switch the transceiver OFF and
then ON again.
Revert Channel
During Scan, pressing the PTT switch to transmit will cause the transceiver to select the revert channel.
Your dealer can program the revert channel using one of the following methods:
● Selected: The last channel selected is assigned as the new revert channel.
● Selected + Talkback: If the channel has been changed during Scan, the newly selected channel is
assigned as the new revert channel. However, the transceiver also transmits on the channel where
Scan is currently paused.
● Priority: If your dealer has programmed a Priority channel, it is the revert channel.
● Priority + Talkback: If your dealer has programmed a Priority channel, it is the revert channel.
However, the transceiver also transmits on the channel where Scan is currently paused.