WIRELESS PC+A/V TRANSMITTER RECEIVER 2.4GHz A/V Receiver 2.
Contents
12 1 4. Precautions 4.1 Normal phenomenon Interruption appears when moving. As adopting RF control technic , there will be momentary interruption in the picture when use remote control. The distance varies according to the surroundings, the ordinary house can reach about 10-20 meters. But if the wall is of iron and concrete, it will largely muffle the signal (may not receive signal or shorten receive distance) 1. Introduction 1.
2 11 2) TRV2402 Receiver 3) Image adjusting menu Power input: DC 5V 300mA 2.4GHz channel: 4 channels (2414, 2432, 2450, 2468MHz) Mouse type: PS/2 port Video output: 1Vp-p (PAL/NTSC) Audio output: 1.5Vp-p (L/R) 1.
10 3 3.2 Remote control operation 1) Panel illustration 2. Exterior illustration and installation 2.1 Panel and terminal illustration 1) Transmitter TXV2428 panel and terminal illustration DC-IN USB VGA-IN VGA-OUT PC-AUDIO 2.
4 9 3) Channel selection 2.2 Connection Press channel switch to convert to four 2.4GHz channels. 1) Transmitter TXV2428 connection Notice: Only when the receiver and the transmitter in the same channel, can the A/V signal be normally transmitted. PC connection: Channel selected status indicator as below: Host Monitor Power adaptor AV VGA cable Stereo audio cable USB cable Channel1 selected status DC-IN USB VGA-IN VGA-OUT PC-AUDIO 2.
8 5 3. Operation illustration 2.3 Product placing Transmitter TXV2428 placing: 3.1 Panel operation 1) Signal CH selection Press source switch to convert to PC/AV (refer to exterior illustration to get PC/AV input terminal). Only when transmitter and the receiver are in the same channel, signal can be transmitted normally. Transmitter (TXV2428) will automatically follow your operation instruction to switch to signal channel when you have PC/AV switching operation on the side of the receiver (TRV2402).
6 7 Receiver TRV2402 placing: 2) 433MHz antenna Put receiver TRV2402 beside TV set, power on and connect AV cable according to the corresponding colors (yellow/white/red) Pay attention to the place of 433MHz antenna and make sure no obstacle around (especially metallic obstacle which seriously affects the signal retransmission). Stretch out the antenna and place as below: TV Receiver TRV2402 Vertical view Right view DC-IN IR R L VIDEO PS/2 MMI 2.
