Operation Manual

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
 Hazardous substance list
Part
name
Hazardous substance
Plumbum
（Pb）
HG
Cadmium
（Cd）
Hexavalent
chromium（Cr(VI)）
Polybrominated
biphenyls（PBB）
PBDE
Shell
○
○
○
○
○
○
Main
board
○
○
○
○
○
○
cable
○
○
○
○
○
○
This form is prepared in accordance with SJ / T 11364。
○:It means that the content of this hazardous substance in all homogeneous materials of this
part is below the limit requirement specified in GB / T 26572;
×:Means that the content of the hazardous substance in at least one homogeneous material of
the part exceeds the limit requirement specified in GB / T 26572
Notes to symbols: This electrical product contains certain harmful substances, which can
be used safely during the environmental protection use period, and after the
environmental protection use period is exceeded, it should enter the recycling cycle
system.
 Failures and solutions
Failure phenomenon
Failure cause
Solutions
1
Plug in the power cord,
the light is still off
The plug is not
tight
Tighten or replace the plug
2
Power bank plugged into
the station then
Power bank
detection failed
Clear the contact point of power bank
and try to return it again