Installation & Operation Guide

Page 08
13. Installing Batteries
a. Insert 4 AA high quality Alkaline batteries into the Battery Compartment in the
direction noted +/- on the Compartment. The Lock will beep 2 times, the keypad
will illuminate blue, and the Clevr button will green twice to signify that
it has received power (Figure 13a).
b. Slide the Battery Cover down into the track on the Interior Assembly to cover
the batteries (Figure 13b).
14. Testing Lock
With the Door Open
a. Test the Lock using the Interior Knob. The bolt should move smoothly.
b. Test the lock using the Keypad. To lock press and then press “ 123456 ”
to unlock.
INSTALLING INTERIOR ASSEMBLY (CONT.)
NOTE: Do not touch the Keypad until the blue light turns off.
Do not use rechargeable batteries or non-alkaline batteries.
Figure 13a-b
INSTALLATION OVERVIEW
Touchscreen
Override
Access Key
Battery
Cover
Interior
Knob
Exterior Assembly Interior Assembly
Fingerprint
area
5/16”(8mm)
Screws(2ea.)
1”(25mm)
Screws(1ea.)
Battery cover
Interior Assembly
Optional1”(25mm)
Screw(1ea.)
Mounting Plate
Latch
3/4”(19mm)
Screws(4ea.)
Touch Keypad
Assembly
Key
Strike Plate