Users Manual

9
7. The requirement for KDB 996369 D03:
7.1 List of applicable FCC rules
FCC Part 15. 249.
7.2 Summarize the specific operational use conditions
None
7.3 Limited module procedures
The Module is limited to manufacturer's host devices only.
7.4 Trace antenna designs
The module uses the permanent PCB antenna, so this requirement is not applicable to the product.
7.5 RF exposure considerations
The host device manufacturer should confirm that a separation distance of 20 cm or more should be
maintained between the antenna of this host device and persons during the host device operation.
7.6 Antennas
PCB antenna, 0dBi
7.7 Label and compliance information
If this certified module is installed inside the host device, then the outside of the host must be labeled with
“Contains FCC ID: 2AJJGHJRF”.
7.8 Information on test modes and additional testing requirements
The host manufacturer can use the software to make RF transmit continuously.
7.9 Additional testing, Part 15 Subpart B disclaimer
The module only complies with the FCC Part 15.249. If the module is installed in the host device, the host
manufacturer is responsible for the compliance to any other FCC rules that apply to the host not covered
by the modular transmitter grant of certification. For example, if the host manufacturer markets their
product as being Part 15 Subpart B compliant (when it also contains unintentional-radiator digital circuity),
then the host manufacturer shall provide a notice stating that the final host product still requires Part 15
Subpart B compliance testing with the modular transmitter installed.