User's Guide

Disposal and recycling information
The crossed-out wheeled bin symbol on your product,
battery, the literature or packaging reminds you that
all electronic products and batteries must be taken
to separate waste collection points at the end of their
working lives; they must not be disposed of in the normal
waste stream with household garbage. It is the respon-
sibility of the user to dispose of the equipment using
a designated collection point or service for separate
recycling of waste electrical and electronic equipment
(WEEE) and batteries according to local laws.
Proper collection and recycling of your equipment helps ensure electrical and
electronic equipment (EEE) waste is recycled in a manner that conserves valuable
materials and protects human health and the environment, improper handling,
accidental breakage, damage, and/or improper recycling at the end of its life
may be harmful to health and environment. For more information about where and
household waste disposal service or visit the website www.pico-interactive.com.
Controller:
Frequency Range (2.4GHz): 2400-2483.5MHz
Max Output Power: 2dBm
This equipment may be operated in
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential in-
stallation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful in-
terference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the fol-
lowing two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that
may cause undesired operation.
rof
elbisnopser ytrap eht yb devorppa ylsserpxe ton snoitacfiidom ro segnahc ynA
compliance could void the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void
the user’s authority to o perate the equipment.
FCC RF radiation exposure statement
“Supplier’s Declaration of Conformity 47 CFR §2.1077 Compliance Information”
SDOC Website: www.pico-interactive.com/certifications/SDOC_neo3.pdf
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other a
ntenna or transmitter.
5655