User's Manual

6
8. The requirement for KDB 996369 D03:
8.1 List of applicable FCC rules
FCC Part 15. 247 and FCC Part 407.
8.2 Summarize the specific operational use conditions
None
8.3 Limited module procedures
The module is a single module, so this requirement is not applicable to the product.
8.4 Trace antenna designs
The module uses the permanent PCB antenna, so this requirement is not applicable to the product.
8.5 RF exposure considerations
The host device manufacturer should confirm that a separation distance of 20 cm or more should be
maintained between the antenna of this host device and persons during the host device operation.
8.6 Antennas
For Bluetooth: PIFA antenna, 0.32dBi
For WiFi 2.4G Band: Ant0: 0.98dBi, Ant1: 0.98dBi
For WiFi 5G Band: Ant0: 1.83 dBi, Ant1: 1.53dBi
8.7 Label and compliance information
If this certified module is installed inside the host device, then the outside of the host must be labeled
with “Contains FCC ID: 2AJVQ-7668AUFT and IC: 22470-7668AUFT”.
8.8 Information on test modes and additional testing requirements
The host manufacturer can use the software of Combo Tool to make the Bluetooth transmit
continuously, and the software of QA Tool to make the wifi transmit continuously.
8.9 Additional testing, Part 15 Subpart B disclaimer
The module only complies with the FCC Part 15.247 and FCC Part 15.407. If the module is installed in the
host device, the host manufacturer is responsible for the compliance to any other FCC rules that apply to
the host not covered by the modular transmitter grant of certification. For example, if the host
manufacturer markets their product as being Part 15 Subpart B compliant (when it also contains
unintentional-radiator digital circuity), then the host manufacturer shall provide a notice stating that the
final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.