User Manual

ManualsBrandsQihan Technology ManualsOtherSanbot S1 Cloud-Based IoT Humanoid Development Platform (Open Box)

ROBOT USER MANUAL

Part Four About Battery Charging

1. Place the Charging Pile

There are two ways to place the charging pile of the robot.

(1) Placing on the ground flat

Let the charging metal sheet of the charging pile outward and lean it against a smooth wall. In order not to disturb the robot when it moves, please place the power wire

along the wall and make sure there is no barriers, wires, cords, etc. within two to three meters around the charging pile. Because when robot receive infrared signal

reflection by other obstacles will lead charging failure, or avoid the robot be tripped by it.

(2) Placing on the ground flat and wall-mounted

Place the charging pile on the ground. Choose a position with appropriate height on the wall and drive two nails into the wall. Make sure that the distance between the two

nails should be in accord with the distance between the two wall-mounted holes in the charging pile. Raise the charging pile, let the two nails fix the wall-mounted holes and

then put the charging pile on the ground so that the charging pile is fixed to avoid from tottering.

2. Charging Mode

When you use the charging pile for the first time, please open the cover of the adapter compartments and take the adapter out. Connect the power wire in the packing box