Phau Ntawv Qhia

6
ovente.com
USING YOUR fan heater
Remove fan heater from its carton and unwind the cord to its full length.
Place on a firm, level desk or table in a stable, upright position.
Make sure the function switch is turned to 0 (off).
Plug the cable into a 110-120V (60Hz) AC power outlet. To avoid an
electrical circuit overload, be sure that no other appliances are plugged
into the same circuit.
FAN
For fan-only operation, without any heat output, turn the function switch to
and rotate the thermostat to your preferred position. The power
indicator light will go on to let you know the fan is operating.
HEATING
Turn the function switch to “I” for the 750W heat setting and “II” for the
1500W heat setting.
To conserve energy use the 750W heat setting initially and then switch to
the 1500W heat setting.
1
2
3
4
THERMOSTAT CONTROL
Before setting the thermostat, allow the heater to operate and
warm up the room. Then set heater to High (the thickest block on
the right of the thermostat).
Once the desired temperature is reached, lower the thermostat
setting until the fan heater stops operating.
The fan heater will cycle on and off to maintain the temperature
you set.