Use and Care Manual

www.QEP.com
Professional Tools for Professional Results
M2721-11806
A
1. Mark where the hole is to be drilled.
2. Be sure that the blue Drill Guide is
ush to the Water Reservoir.
3. Peel paper from one side of Mounting
Tape and attach to the surface of the
blue Drill Guide, centering the hole
around the lip. Press rmly. (A)
B
4. Remove cap on Water Reservoir and
ll with water to bottom edge of the
Drill Guide. Reattach cap rmly. (B)
5. Remove remaining paper from
Mounting Tape. With Water Reservoir
cap facing up, align the mark on the
wall to the center of the Drill Guide.
Press rmly to adhere.
C
6. Insert Drill Bit into Drill Guide.
Rotate Water Reservoir 180
degrees and drill the hole. (C)
How To Use