Use and Care Guide

5. Electrical Requirements before spa delivery

Important

When installed in the United States, the electrical wir-

ing of this spa must meet the requirements of the

National Electric Code (NEC) and any applicable state

or local codes. The electrical circuit must be installed

by an electrical contractor and approved by a local

building/electrical inspector.

Electrical setup before delivery of your spa

1. All 240Volt spas must be permanently connected (hard

wired) to the power supply. Supplying power to the spa

which is not in accordance with these instructions will void

both the independent testing agencies listing and the

manufacturer’s warranty.

2. The power supplied to the spa must be a dedicated circuit

with no other appliances or lights sharing the power.

3. To determine the current, voltage and wire size required for

the spa configuration to be connected:

Wire size must be appropriate per NEC and/or local

codes. (Minimum #6 wire Required)

Wire size is determined by length of run from breaker box

to spa and maximum current draw.

Minimum # 6 copper wire with THHN insulation.

All wiring must be copper to ensure adequate

connections. Do not use aluminum wire.