Manualshelf

Pre-Delivery/Install Checklist

ManualsBrandsQCA Spas ManualsOtherSalina 4 to 5-Person Dura Shell 16 Stainless Steel Jet Plug and Play Spa with 1.5 HP Pump, LED Light and Hard Cover
11121314151617181920
7. Electrical Installation Of Spa After Delivery
(220/240 Volt Spas) Important Safety notice for all models!
Proper grounding is extremely important.
For QCA Spas
Control Packs
VS 300
VS 501
VS 515
QC 2000
BP 2000
1. To gain access to the spa’s control box, remove the cabinet
access panel on the front of the spa, under the spas topside
control. After removing the access panel, remove the two
control box cover screws and cover.
2. Select the power wire inlet through the spa cabinet you
want to use. (Either drill a hole through the cabinet or run wire
in conduit through the base of the spa.) Then feed the power
cable through it to the left side of the control box.
3. Run power wire through the circular hole on the left side of
the control box.
4. Connect wires, color to color, into the terminal openings
and tighten securely. Connect ground wire to the ground
terminal and tighten securely.
5. Secure the control box door by installing its screws, then
re-install the cabinet access panel under the topside control.
USE COPPER 240V
WIRE MIN. 6AWG. 40A 60HZ
S
Y
S
T
E
M
B
O
X
Neutral Hot Hot Ground
W
H
T
B
L
K
R
E
D
G
R
N
CIRCUIT BOARD
GROUND
WHITE (NEUTRAL)
BLK (HOT)
RED (HOT)
GREEN (GROUND)
TB1
17