Use and Care Manual

Phase 3: Sanitizing the Spa

Spa Breeze™ offers two options in

chemical sanitizers Brom 61 bromine

tablets or Chlor 62 granular chlorine.

Each method offers prevention and

control of bacteria that can grow in the

warm environment created by your spa.

Natural mineral purification can also be

used to enhance the effects of bromine

or chlorine such as a Spa Mineral

Cartridge or a professionally installed

ozone system. While these items aid in

sanitation, they are not a replacement

for bromine or chlorine.

Brom 61

Place Brom 61 tabs in the chemical feeder. Then add 2 ounces of

Brom Start directly to the water. Allow the spa to circulate until a

bromine reading of 3 - 5 ppm is attained. Do not use your spa until you

have obtained a 3 - 5 ppm reading. You may have to adjust the feeder

to maintain a 3 - 5 ppm level. Check the bromine levels before each use

to insure a proper reading. Check the feeder regularly to make sure

there are enough tablets in the feeder. Refer to your feeder’s directions

for proper feeder adjustment.

Chlor 62

After your spa has been filled add 1 level tablespoon of chlorine to

supershock the water and to establish a chlorine residual. Allow the spa

to circulate until a chlorine reading of 1 - 3 ppm is attained. Do not use

your spa until you have obtained a 1 - 3 ppm reading. At this time test

the water again to ensure that the pH is between 7.4 - 7.8.If pH is below

7.4 add pH Up and if it is above 7.8 add pH Down.

NOTE: Frequent use, high temperature, and turbulent aerated water

will require more frequent additions of the sanitizer system to maintain

the 1-3 ppm level.