Instruction Manual
BATTERY AND CHARGING INSTRUCTIONS
1: To charge the battery, connect the speaker to an electric outlet with the include power cord.
2: Make sure to fully charge the battery before using for the first time to enhance the battery life and play time.
3: The unit takes approximately 6 hours to fully charge. It will automatically start charging once the power cord is connect
to an electric outlet.
4: To maximize the battery life span, please make sure to charge the battery at least once every 30 days.
5: Use the power switch to turn off the unit if not in use.
***CAUTION!!!
Do not leave the battery unattended around children. Exposed metal or exposed clamps could heat up in the process.
***WARNING!!!
1: Before operating this unit, please read the manual completely and save it.
2: The unit contains high voltage components. DO NOT open it under any circumstances.
3: DO NOT plug or unplug the unit with wet hands.
4: If the unit is damaged, DO NOT open it, it needs to be repaired by a qualified technician.
5: DO NOT place the unit near a wet floor or heat sources, and keep out of the reach of children.
6: After long continuous usage, the panel might become slightly hot. Do not touch it or operate carefully to avoid a
potential burn.
7: Under USB / TF / FM / LINE / BLUETOOTH mode if there is any interference around the speaker, it will cause noise.
8: Be sure to turn off the switch when speaker is in charging, speaker is not recommended to use when it’s in charging.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
PAGE—4--