Phau Ntawv Qhia

ManualsBrandsQAB MB ManualsTuned SystemMB QUART MBQG-RAD-1 Polaris General Tuned System

Page 1 of 8

Installation Instructions

Model:

Polaris General

Description:

Radio Install

Part Number:

MBQG-RAD-1

Assembly Time:

45 Min

No. Component Name Qty

1 GMR-LED with Housing (MBQG-RAD-1) 1

1 Bojo Tool

2 7mm wrench

3 T25 Torx Driver

Parts List

Tools Required

Before you begin, read through these instructions and check that

all parts are present. Always disconnect negative battery terminal

prior to installation. Please note that MB Quart cannot assume any

responsibility for damage resulting from incorrect installation.

Summary of content (8 pages)

PAGE 1
Installation Instructions Model: Polaris General Description: Radio Install Part Number: MBQG-RAD-1 Assembly Time: 45 Min Before you begin, read through these instructions and check that all parts are present. Always disconnect negative battery terminal prior to installation. Please note that MB Quart cannot assume any responsibility for damage resulting from incorrect installation. Parts List No.
PAGE 2
Dash Disassembly ● Remove hood by turning two latches ● Remove seven push clips from front of dash Page 2 of 8
PAGE 3
Dash Disassembly ● Remove top two push pins from driver and passenger door opening ● Lift front of dash at eight locations with Bojo tool Page 3 of 8
PAGE 4
Dash Disassembly ● Remove upper pocket assembly Page 4 of 8
PAGE 5
Radio Install ● Install two double threaded bolts in back of radio with 7mm wrench ● Place radio and dash kit from the front side of the dash ● Position rear bracket and loosely install the two nuts on back of radio Loosely install four High-Low threadforming screws with a T25 Torx Position radio in opening moving left and right and up, and down, once happy, tighten the nuts on the back of the radio with a 7mm wrench and T25 Torx on the bracket Page 5 of 8
PAGE 6
Reassembly ● Install top of dash, snapping eight push clips on front of dash ● Install six push pins on front of dash Page 6 of 8
PAGE 7
Reassembly ● Install hood Page 7 of 8
PAGE 8
FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a mobile installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.