Manual

Q-TECH Corporation - 10150 W. Jefferson Boulevard, Culver City 90232 - Tel: [phone] - Fax: [phone] - www.q-tech.com
7 of 27
Q-TECH
CORPORATION
QPDS-0001, Rev L, June 2013 (ECO #10851)
CLASS B+ PRODUCTS
HIGH RELIABILITY HYBRID CRYSTAL CLOCK OSCILLATORS
2.5 to 5.0Vdc - 15kHz to 350MHz
Screening - Option S (Modified MIL-PRF-38534, Class K)
Table I
(Example: QT178LD10S-50.000MHz)
NOTES:
1. PIND testing shall be performed using five (5) independent passes and all failures found at the end of each pass are rejected. The
survivors of the last pass are acceptable.
2. Normally frequency aging is up 30 days. However, aging may be ceased if value at 15 days is half than the limit of 30-day aging
value, or continued up to 90 days if value exeeds 30 day aging limit.
Tests Parameters Symbol Delta Limits
Burn-In # 2 Supply current Icc ±10% of initial reading
Life Test after 1,000 hours at +125°C Supply current Icc (Life) ±10% of initial reading
Frequency Aging after 30 days at +70°C Output Frequency Fo Refer to detail spec.
Table I-a
Delta Limits
Test Description
MIL
Standard
Method Condition Qty Comments
Non Destructive Bond Pull 883 2023 100%
Except on ceramic packages
Internal Visual 883 2017 Class H 100%
Stabilization Bake 883 1008 C 100% 48 hours at +150°C
Temperature Cycling 883 1010 C 100% 10 cycles
Constant Acceleration 883 2001 A 100% Y1 direction only (5,000g’s)
Particle Impact Noise Detection (PIND) 883 2020 B 100%
5 passes minimum
(See Note 1)
Pre Burn-In Electrical Refer to Table I-b and Detail Specification 100%
Burn-In # 1 883 1015
+125°C
for 160 hours
100% With load and nominal supply voltage
Interim Electrical Refer to Table I-b and Detail Specification 100%
Burn-In # 2 883 1015
+125°C
for 160 hours
100% With load and nominal supply voltage
Final Electrical Refer to Table I-a, I-b and Detail Specification 100%
Percent Defective Allowance (PDA) 38534
Refer to table 1-a
below
PDA=2% (Supply Current only)
Seal Fine Leak 883 1014 A1 100%
Seal Gross Leak 883 1014 C 100%
Radiographic Inspection 883 2012 Class S 100%
Frequency Aging 30 days 55310
+70°C±3°C
Refer to Table I-a
below
100%
±1.5ppm max. for F≤150MHz
±2ppm max. for >150MHz < F ≤ 200MHz
±2.5ppm max. for F > 200MHz
(See Note 2)
External Visual 883 2009 100%
Option S - Continue
Back To Summary