Full Product Manual

4
This outdoor patio heater must be used for outdoors only in a well ventilated area and not
be used in a vehicle or any enclosed building or space.
Always place the heater on a level stable surface.
Do not move or touch the heater while it is hot or burning.
Do not alter or modify the heater in any manner.
Always keep at least a 3 ft. (.914 m) clearance from the heater to any combustible material.
This Heater is to be used on a flat level non-combustible surface only.
Install on flat level non-combustible surface (concrete, tile, stone, etc.)
Do not use the heater if the wind velocity is greater than 10 miles per hour.
Do not spray aerosols near the heater while in use.
Do not clean heater with combustible or corrosive cleaners. Use warm, soapy water.
Do not hang clothing or flammable materials either on or near heater.
Allow 60 or more minutes for the heater to cool down after use before attempting to move
your heater.
Do not operate a damaged heater.
Never use petroleum based flammable vapors or liquids in or near this heater
Warning:
When the heater is to be operated in the presence of other people, the owner/purchaser is
required to inform people unfamiliar with the operation of the patio heater of the
instructions, and of the hazards involved of operation. If this heater is used in a commercial
or rental installation, it is the responsibility of the purchaser to check with the local codes
for properly inform the user of the safety precautions and instructions. The owner’s manual
should always stay with the unit.
Failure to comply with the precautions and instructions provided with this heater can result
in death serious bodily injury and property loss or damage from hazards of fire, explosion,
burn, asphyxiation or carbon monoxide poisoning. Be sure you understand all operation
instructions before attempting to operate or service this heater. QSTOVES WILL NOT BE
RESPONSIBLE FOR INJURY, DEATH OR PROPERTY DAMAGE IF INSTRUCTIONS IN THIS
MANUAL ARE NOT FOLLOWED.
1. Assembly
Note: Partial assembly has been done for you. The assembly of this heater requires basic
mechanical skills. Proper assembly is the responsibility of the purchaser. All service and
repairs should be done by a qualified person.