User manual

62
Ba sic sy s te m re se t (3 se c)
After pressing the reset button for 3 seconds, a beep sound will be heard. The following settings will be
reset to default:
System administration password: admin.
TCP/IP configuration: Obtain IP address settings automatically via DHCP.
TCP/IP configuration: Disable Jumbo Frame.
TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port trunking mode
will be reset to “Active Backup (Failover)”.
System port: 8080 (system service port).
Security level: Low (Allow all connections).
LCD panel password: (blank)*.
VLAN will be disabled.
Service binding: All NAS services run on all available network interfaces.
*This feature is only provided by the NAS models with LCD panels. Please visit http://www.qnap.com
for details.
A dv anc e d sy s te m re se t (10 se c)
After pressing the reset button for 10 seconds, you will hear two beeps at the third and the tenth
seconds. The NAS will reset all the system settings to default as it does by the web-based system reset
in “Administration” > “Restore to Factory Default” except all the data are reserved. The settings such as
the users, user groups, and the network shares previously created will be cleared. To retrieve the old
data after advanced system reset, create the same network shares on the NAS and the data will be
accessible again.