User`s manual

User’s manual of remote client software
NOTE: the size of map is limited to 5M per map.
Right click on the map to add different icons for alarm spots.
Fig 2.8.6 Hotspot Information Interface
And the alarm spot is in correspondence with the present equipment in the left. After
successful add, the setup interface is showed as Fig 2.8.7:
Fig 2.8.7 Electronic Map Interface
The spot name in the hot spots list in the lower right corner is the lower layer map belongs to
the present map. Select one map from the lower right corner hot spots list, press Shift (or Ctrl) at
the same time, then you can add (or delete) hot area on the map. The red area is corresponding to
the unselected hot spots list, while the blue area corresponds to the selected hot spot list.
Besides, you can click “delete” to erase all corresponding areas; and you can click “exit” to
exit the setup interface.
If you have set electronic map alarm, then corresponding hot spot will flash when alarm
- 69 -