User Manual
10
Step 7: Startup Wizard
In order to eectively use the search functions and
maintain accurate recordings, you must complete the
Startup Wizard. To prevent the wizard from appearing
after each reboot, uncheck Enable wizard next time.
Click on Wizard Setup to begin.
D. Turn on the DVR’s power switch (if present). The
DVR may beep as it powers up and the Startup
Wizard will appear on-screen after a few minutes.
C. Plug the camera power supply into a surge
protector.
NOTE: If wizard does not pop up, shut down the DVR for
30 seconds and turn power back on.
NOTE: The camera will make a faint clicking sound when
the power is activated.