Technical Manual

QSDR16RTCB User Manual

5.2: Main Menu

The right-click menu in the Main Interface mode (Picture 3) allows you

to access the Main Menu interface (Picture 4). You can use the right

click function of the mouse or the Menu button on the front panel of

the DVR to enter into the Main Menu interface. Use the mouse or the

FWD and REW button on your DVR’s front panel or remote control to

navigate around the Main Menu Interface and select the icon of the

program you wish to access (See Picture 4). Use the ESC button on

your DVR’s front panel to return to the previous window of the Main

Menu interface. Set your management permissions, configure your

devices, customize your recording parameters, and access your

System Functions (such as time, date and passwords) through the

Main Menu Interface. You can also configure the controls for your

Camera, Network, HDD, Alarm, PTZ, & Mobile Phone controls

through the Main Menu Interface.

5.2.1: Camera Setup

To set up the display name and position display of each camera, go to

[Main Menu  Camera] and you will receive a Camera Setup

interface (Shown as Picture 5). Through the Camera Setup interface,

you are able to choose a name for each of your connected cameras

up to 8 characters long. You can also adjust the image brightness,

saturation, contrast and hue settings of each camera. To do this,

push the SETUP button in the [Color] Menu and make the desired

changes. The Camera Setup interface also gives you the ability to

choose which camera channels you wish to enable live viewing of and

which camera channels you wish to set up with the ability to record.

Please note that any modifications you make through the Camera

Setup interface will not be applied until you click the [APPLY] button at

the bottom of the dialog box (Picture 6). Once you do this, you will

then be prompted to save your settings, and you must click [OK] in

order for the changes to take effect. If you wish to abort the changes

you made, simply click the [Exit] button on the bottom of your dialog

box (Picture 6). By clicking on the [DEFAULT] button at the bottom of

your Color Setup dialog box (Picture 6) all system default values will

be reset to their original factory installed settings.

(Picture 4)

(Picture 5)

(Picture 6)