Setup guide

IMAGE 12 IMAGE 18

NOTICE: You need to put your public DNS. This can be found in your Router Status tab.

Usually there are 2 DNS entries (DNS1 & DNS2). Use DNS 1 only. If you router does

not list the DNS address get it from your Internet Service Provider.

7. Enter the User Name, Password and Domain Name that you registered for through

http://myq-see.com. Click the APPLY button at the bottom of the screen and then the

EXIT button. This should return you to the Network Setup menu.

8. Click the APPLY button and then the EXIT button at the bottom of the Network Setup

Screen and your DDNS setup is complete.

PORT FORWARDING

To access the DVR from a remote computer

You need to forward ports 80 and 9000 from the router the DVR is attached to, to the IP

address of the DVR.

First connect your DVR to the Router and power on DVR, then follow these steps to conﬁgure

your DVR and Set up port forwarding on your router

1. Go to www.portforward.com/qsee

2. Choose your DVR or Series (QT, QSDT, QR, QS etc) from the list provided

3. Select the make and model of your router from the list

4. Click on the ‘Click here to skip this advertisement…’ link in the upper right corner

of the screen.

Note: When you go to the www.portforward.com website you will see an ad for a software

program that will setup port forwarding for you. You do not need to buy this software.

Above the ad there is a link to skip the ad, if you click on the link it will take you to the

instructions which are free. You can purchase the software if you want to, but you do not

need to pay to get the port forwarding instructions.

RemoteMonitorGuide.indd 7 10/20/2010 4:43:38 PM