Technical Manual

12 13
System
Main Processor Texas Instruments DaVinci high-performance DSP
OS LINUX
System Resources Supports simultaneous real-time network, local record, and
remote operation
User Interface Remote operation through Web Service and PSS
System Status SD card status, bit stream stats, log, and software version.
Image Sensor 1/3” 2.0 Mp SONY progressive scan Exmor CMOS
Min. Illumination 0.2LUX/F1.6 (color), 0.01LUX/F1.6 (b/w)
Lens Auto-Iris 3.6@F1-6
Video
Pixel 1920x1080 (1080p)
Day/Night Mode Automatic
Auto Aperture DC drive
Gain Control Fixed/Auto
White Balance Manual/Auto
Exposure Mode Manual/Auto NTSC: 1/4-1/10000
Video Comp.
Standard
H.264/JPEG/MJPG
Video Frame Rate NTSC: Main stream 1080P @30fps, 1.3M @30fps, 720P
@30fps; Substream 704x480@30fps
Video Bit Rate H.264 56Kbps-8192Kbps
MJPG is adjustable along with bit rate
Snapshot 1f/s snapshot. Files saved as JPG
Privacy Mask Maximum 4 privacy zones supported
Video Adjustment Brightness, contrast, hue, saturation and gain
Video Info Channel title, time, motion detection, masking
Motion Detect 396 (18x22) zones. Six sensitivity levels. Motion detection
activation options: alarm, recording, snapshot, log and e-mail
Network
Network 1-channel wire Ethernet port, 10/100 Base-T Ethernet
Network Protocols Standard HTTP, TCP/IP, ARP, IGMP, ICMP, RTSP, RTP,UDP,
RTCP, SMTP, FTP, DHCP, DNS, DDNS, PPPOE, UPNP, NTP,
Bonjour,SNMP.
Remote Operation Monitor, system setup, file download, log information,
maintenance and upgrade.
Recording
& Backup
Recording Priority Manual>External alarm >Video detect>Schedule
Local Storage 32GB internal
Backup Remote through PSS
Power
Power Through RJ45 connector when connected to POE or 12v .5A
through aux. power connector
Consumption <10W
Env.
Temperature 15F to 140F
IP Rating IP66
Humidity 10-90%
QCN8001D
PICTURE 1-4
MOUNTING AND ADJUSTING DOME CAMERAS
Remove the camera cover using the included hex wrench to unscrew the three retaining bolts.
PICTURE 1-5
The camera’s lens can only be positioned
vertically (up and down) with the horizontal
direction being determined by how the
camera is positioned. Ideally, you should
temporarily connect the camera to the NVR
(or network) and use the QC View mobile
app to determine the best angle for your
camera.
Once you’ve determined the proper position
and location for the camera, use the included
mounting template to drill the holes for the
plastic anchors and cable (if needed).
insert the screws into the anchors through the camera base plate and tighten. If the camera is
connected, then make final adjustments to the lens position. Make sure that the clear dome is
free of dust, fingerprints and other contaminants before reattaching the cover.
RESET BUTTON AND SD CARD
Both the QCN7002D and QCN8001D have a Reset button accessible only when the camera
cover has been removed. This is only for use if the camera becomes inoperable.
The QCN8001D also has a slot for a Micro SD card which allows the camera to record images
and video when it is operating on its own network (ie; not directly connected to the NVR with
the Ethernet cable. Please see Section 3.5 for instructions on recording with an SD card.