- Digital Peripheral Solutions Computer Hardware User Manual

SuperDVR & H.264 Series Cards

User Manual

Error! Use the Home tab to apply

标题

1 to the text that you want to

appear here. Error! Use the Home

tab to apply

标题

1 to the text that

you want to appear here.

2.1.5 Alarm Board Hardware

Figure2-13 Alarm Board

Figure2-14 Pins Definition of Alarm Board

Connect J2 to PC serial port and you can use alarm board on SuperDVR

system.

2.1.6 Connect Audio Signal

For QSDT4PCRP, connect the audio input device to the microphone

connector on the motherboard.

Before installing the Video Capture Card hardware in PCI port of the

motherboard, make sure you’ve installed Microsoft DirectX 9.0 or later. Then

turn on the computer, the system will display ‘Found new hardware’.

NOTICE: Just click ‘Cancel’ and ignore the pop-up message.

Insert the CD that contains H.264 series capture card driver into the CD tray,

and run Setup.exe program to install the driver. The default installation path is

‘C:\Program Files\SuperDVR’.