Installation Guide

3
STEP 2
Locate your breaker box and turn o the
breakers that give power to your doorbell
and chime before working with any wiring.
STEP 3
Go to your existing chime and remove the cover.
Your chime may look dierent than the one shown.
IMPORTANT: Visit www.q-see.com/support to
nd the most recent guides and up-to-date support
for your Q-See products.
NOTE: Battery-operated wireless chimes are not
compatible with the QCW1000 doorbell.
STEP 4
Loosen the screws enough to remove the two power
wires (They may be labeled “FRONT” and “TRANS”).
Straighten out the exposed wires and twist them at
the ends. Before the next step, take the included
chime wire connector and rmly open the two levers
(see photo in next step for reference).