User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 75
PR 91228
On an OS7000 series switch, the system does not detect IPv6 port scanning, nor other IPv6 denial of
service attacks.
Workaround: There is no known workaround at this time.
PR 91898
It is possible to add two IPv6 configured tunnels with the same source and destination IPv4 addresses.
This is discouraged since it may have some unusual consequences.
Workaround: Create only a single IPv6 configured tunnel with the same source and destination IPv4
addresses. Since multiple IPv6 addresses may be assigned to a single tunnel, more than one with the same
IPv4 addresses is never necessary.
PR 92215
Modification of IPv6 interface MTU does not change MTU size in Ripng and hence RIPng update packet
size also does not change.
Workaround: There is no known workaround at this time.
PR 92225
The traceroute command can usually be stopped while in progress by pressing any key from the console
session. However, if a probe returns an error "probe transmission failed", the command does not exit until
the configured timeout has expired.
Workaround: There is no known workaround at this time.
PR 92270
IPv6 static and local routes remain in the up state, even when the interface used to reach their destination
is down.
Workaround: There is no known workaround at this time.
PR 92663
If a duplicate address is detected, the error message is only shown on the console screen. It neither appears
on a telnet session nor saved in the swlog log file.
Workaround: There is no known workaround at this time.