User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 61
PR 80435
On an OS8800 switch, if you change the protocol to 1W in the root switch first, chances are the root
switch would still receive 1D BPDUs from other switches, causing the root switch to revert back to 1D.
Workaround: Please change the protocol on the non-root switches first, and then do the root switch last.
PR 84695
On an OS6600 series switch, even after configuring a permanent MAC address for a link aggregate port,
the address is learned as a dynamic MAC address.
Workaround: There is no known workaround at this time.
PR 86276
On an OS7000 series switch, the LPS violation trap sent does not include system Date and Time.
Workaround: There is no known workaround at this time.
PR 89161
On an OS8800 switch, some of the ports show 0 MACs learned after an NI is powered down and up.
However, the MACs are still being learned correctly at the NI level.
Workaround: Flush the entire MAC table to allow the CMM to have the proper MAC count.
PR 89580
An OS6600 series switch shows the IP-SNAP protocol number as zero.
Workaround: There is no known workaround at this time.
PR 89601
On an OS6600 series switch, AARP is learned as aaaa0000 instead of aaaa80f3.
Workaround: There is no known workaround at this time.
PR 90570
On an OS6600 series switch, the permanent MAC addresses on link aggregates might show as "learned"
instead of "permanent".
Workaround: There is no known workaround at this time.