User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 49
PR 83996
Query Max Response Time cannot be set through CLI or WebView on an OS7000.
Workaround: This can be set through SNMP variable igmpInterfaceQueryMaxResponseTime.
PR 84009
It is not possible to configure an interface as IGMPv1 through the CLI or WebView on an OS7000 series
switch.
Workaround: Configure an interface as IGMPv1 through SNMP.
PR 89462
Ingress IGMP packets are not mirrored to the destination port.
Workaround: There is no known workaround at this time.
PR 90069
Received IGMP reports are not proxied as V3 reports when IGMP proxy version is configured as V3 on
an OS7000 series switch.
Workaround: There is no known workaround at this time.
PR 90688
A static member configured on port 'p' and VLAN 'v' for multicast-stream 's' will receive 's' even if 'p' is
not a member of 'v'. The received traffic is untagged.
Workaround: To stop receiving traffic, remove the configuration. To receive the traffic tagged, config-
ure 'v' tagged on 'p'.
Learned Port Security
Problem Reports
PR 71412
When Learned Port Security is configured on an OS6624/6648 series switch, traffic is flooded until MAC
addresses are learned.
Workaround: Directly create the objects in an active state. Thereby, bypassing this problem by previ-
ously configuring together both sides of the static aggregates, with aggregation set "disable". Therefore,
the "admin state" must be set to "disable" just after the creation. When the whole configuration is ready,
set the admin state to "enable" such as it is by default. There is also the possibility of setting down/up
ports. Thus, interfaces could also be set admin "down/up" before everything is ready.