User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 39
PR 81067
WebView's Physical Modules Summary information does not sort the slot column data properly.
WebView is using a numerical sort, which is not ideal for data in this column. However, all slot data is
displayed.
Workaround: There is no known workaround at this time.
PR 81316
The Chassis Hardware Information page does not show the Firmware Revision on an OS6600 chassis.
Workaround: There is no known workaround at this time.
PR 81755
On an OS8800 switch, in WebView, Networking > IP > BGP4 > Neighbor Settings page, the columns "In
Reconfigure" and "Out Reconfigure" always say "Reconfigure".
Workaround: Please ignore; these columns are extra.
PR 82009
On an OS7000 series switch, sometimes, in the WebView physical adjacencies section, the right-click on
switch in map will not show connected IP addresses when Netscape 4.79 is used on Solaris.
Workaround: It is recommended to use Internet Explorer 6.0 or later, or Netscape 7.0 on Solaris.
PR 82075
The WebView physical console port shows a 9 pin connector instead of an RJ45 for the fiber version of
the OS6600 switches.
Workaround: Please ignore. This is a cosmetic flaw. The console connector is an RJ45.
PR 83005
WebView adjacencies show multiple connections when a link is an aggregate.
Workaround: There is no known workaround at this time.
PR 83794
Menu corruption may occur when selecting VLAN Management Binding Rules under Netscape. The
menu may appear in the middle of the tabular display.
Workaround: Use Internet Explorer 6.