User guide

Supported Traps
page 14 OmniSwitch 6600/7000/8800—Release 5.1.6.R02
29 mirrorUnlikeNi The mirroring configuration is deleted due to
the swapping of different NI board type. The
Port Mirroring session which was active on a
slot cannot continue with the insertion of differ-
ent NI type in the same slot.
30 slPesudoCAMStatusTrap The trap status of the Layer 2 pesudoCAM for
this NI.
31 unused
32 unused
33 slbTrapOperStatus A change occurred in the operational status of
the server load balancing entity.
34 ifMauJabber This trap is sent whenever a managed interface
MAU enters the jabber state.
35 sessionAuthenticationTrap An authentication failure trap is sent each time a
user authentication is refused.
36 trapAbsorptionTrap The absorption trap is sent when a trap has been
absorbed at least once.
37 alaStackMgrDuplicateSlotTrap Two or more slots claim to have the same slot
number.
38 alaStackMgrNeighborChangeTrap Indicates whether or not the stack is in loop.
39 alaStackMgrRoleChangeTrap Indicates that a new primary or secondary stack
is elected.
40 lpsViolationTrap A Learned Port Security (LPS) violation has
occurred.
41 alaDoSTrap
(*See note at the end of the table)
Indicates that the sending agent has received a
Denial of Service (DoS) attack.
42 gmBindRuleViolation Occurs whenever a binding rule which has been
configured gets violated.
43 unused
44 unused
45 unused
46 unused
47 pethPsePortOnOffNotification Indicates if power inline port is or is not deliver-
ing power to the a power inline device.
48 pethPsePortPowerMaintenanceStatusNotification Indicates the status of the power maintenance
signature for inline power.
49 pethMainPowerUsageOnNotification Indicates that the power inline usage is above
the threshold.
50 pethMainPowerUsageOffNotification Indicates that the power inline usage is below
the threshold.
51 ospfNbrStateChange Indicates a state change of the neighbor rela-
tionship.
No. Trap Name Description