User guide

Supported Traps
OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 13
19 bgpBackwardTransition This trap is generated when the BGP router port
has moved from a more active to a less active
state.
20 esmDrvTrapDropsLink This trap is sent when the Ethernet code drops
the link because of excessive errors.
21 pimNeighborLoss Signifies the loss of adjacency with a neighbor
device. This trap is generated when the neigh-
bor time expires and the switch has no other
neighbors on the same interface with a lower IP
address than itself.
22 dvmrpNeighborLoss A 2-way adjacency relationship with a neighbor
has been lost. This trap is generated when the
neighbor state changes from “active” to “one-
way,” “ignoring” or “down.” The trap is sent
only when the switch has no other neighbors on
the same interface with a lower IP address than
itself.
23 dvmrpNeighborNotPruning A non-pruning neighbor has been detected in an
implementation-dependent manner. This trap is
generated at most once per generation ID of the
neighbor. For example, it should be generated at
the time a neighbor is first heard from if the
prune bit is not set. It should also be generated
if the local system has the ability to tell that a
neighbor which sets the prune bit is not pruning
any branches over an extended period of time.
The trap should be generated if the router has no
other neighbors on the same interface with a
lower IP address than itself.
24 risingAlarm An Ethernet statistical variable has exceeded its
rising threshold. The variable’s rising threshold
and whether it will issue an SNMP trap for this
condition are configured by an NMS station
running RMON.
25 fallingAlarm An Ethernet statistical variable has dipped
below its falling threshold. The variable’s fall-
ing threshold and whether it will issue an
SNMP trap for this condition are configured by
an NMS station running RMON.
26 stpNewRoot Sent by a bridge that became the new root of the
spanning tree.
27 stpRootPortChange A root port has changed for a spanning tree
bridge. The root port is the port that offers the
lowest cost path from this bridge to the root
bridge.
28 mirrorConfigError The mirroring configuration failed on an NI.
This trap is sent when any NI fails to configure
mirroring. Due to this error, port mirroring ses-
sion will be terminated.
No. Trap Name Description