User guide

Open Problem Reports and Feature Exceptions
page 108 OmniSwitch 6600/7000/8800—Release 5.1.6.R02
PR 80710
OS7-ENI-P24 modules have egress flood rates lower than the regular OS7-ENI-C24 modules.
Workaround: There is no known workaround at this time.
OmniSwitch 8800 NIs
OmniSwitch 8800 Feature Exceptions
• When a chassis is fully loaded with 5 SFM modules, an Amber light indicates that the module is in the
Stand-By mode.
Problem Reports
PR 66750
The maximum aggregate throughput for an OS8-ENI-C24 (10/100) is 2.0 gigabits/sec.
Workaround: There is no known workaround at this time.
PR 67570
On the OS8-GNI-C8, incoming frames are accumulated by the statistics handler if, and only if, a port is
enabled. If the port is not enabled yet, any incoming frames are dropped. As a result, statistics between the
switch and the traffic generator might be different.
Workaround: There is no known workaround at this time
PR 68883
When the speed is changed on ENI modules (10M to 100M or vice-versa), the far end is supposed to
detect this change if configured as auto. If it does not detect this condition, then the link goes down.
Workaround: Configure the far end or toggle the link status locally to restart the auto negotiation process.
PR 69545
No GBIC information is shown when the show module long command is issued on an OS8-GNI-U24.
This is harmless and does not affect the behavior of the switch.
Workaround: There is no known workaround at this time.
PR 76652
On OS8800 switches, when broadcast packets inflow to a port, if they are mixed with different sizes, some
smaller size packets could be dropped by the system.
Workaround: There is no known workaround at this time.