User guide

Open Problem Reports and Feature Exceptions
page 104 OmniSwitch 6600/7000/8800—Release 5.1.6.R02
PR 83669
The chassis will not be able to bootup when the boot flag is set to 0xb8000 on an OS7000 series switch.
Workaround: Do not set the boot flag to 0xb8000.
PR 84294
The show running-directory command shows Running Configuration as Not Available on an OS6600
series switch.
Workaround: This is a display issue only.
PR 84601
On an OS7000 series switch, daylight savings time is not accommodated in several time zones. NTP
synchronization is off by one hour.
Workaround: There is no known workaround at this time.
PR 86084
The configuration file from 5.1.4 or older releases might not be compatible for autonegotiation if either
speed or duplex is set to non-autonegotiation.
On such releases, autonegotiation is automatically disabled and saved in the boot.cfg configuration file.
Workaround: Enable autonegotiation and save the configuration.
PR 90189
The reload working no rollback-timeout CLI command causes the switch to generate a coldStart trap
when it comes back up again. It should be sending a warmStart trap instead.
Workaround: Ignore this trap.
PR 90193
If the name of a file (1) is the substring of another file (2) on the remote CMM, then an endless flash
synchro situation may occur.
Workaround: Inspect the contents of directories from both CMMs, and remove file (2) from the remote
CMM.
PR 90574
On an OS6600 series switch, a STR status message is sent when the CSM certification is done.
Workaround: There is no impact to the execution code, only the message 0x222 is logged in the swlog.
The user can ignore this message.