User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 101
PR 62067
The Port link may toggle if using a Media Converter (100BASE-TX to 100BASE-FX) on an OS7000
series switch.
Workaround: There is no known workaround at this time.
PR 63605
Some Fweb* images show up in the "loaded m-code" table before an OS7000 series switch reloads.
Workaround: When a switch comes up, the only file that WebView loads is the web.lnk file from
Fweb.img. If there is no web access to the switch, nothing else is loaded. When a user accesses a certain
page, the system dynamically loads the necessary file. The WebView image/s that show up in the show
microcode loaded output is dependent upon what pages were accessed. Therefore, these images can vary
from switch to switch and from time to time.
PR 63661
The message “KERNAL reboots!” may display when changing the system time on an OS7000 series
switch.
Workaround: There is no known workaround at this time.
PR 65248
When an user configures the EMP IP address to "." or 0.0.0.0 in an attempt to clear the address on an
OS7000 series switch, it in fact adds it as the default route (0.0.0.0).
Workaround: There is no known workaround at this time.
PR 66781
The Operating System does not support non-contiguous MAC ranges on an OmniSwitch 8800 switch.
Workaround: There is no known workaround at this time.
PR 66815
If the working directory is in upper case "WORKING" (normally this happen if it is created on a PC), then
the install command from either CLI or WebView removes Hrelease.img from the working directory
getting removed on an OS6624/6648 switch.
Workaround: Rename the upper case "WORKING" directory to a lower case "working" directory. Do
not use rename WORKING working (this will not work). Rename WORKING to something else first
and then rename it back to lower case "working". For example:
rename WORKING ttt
rename ttt working