User guide

Open Problem Reports and Feature Exceptions
page 100 OmniSwitch 6600/7000/8800—Release 5.1.6.R02
PR 60142
When priority 2 and priority 3 traffic is sent at wire rate on all 384 ports of a switch, 40 percent of the traf-
fic is dropped.
Workaround: Configure the network applications and the switch QoS parameters so that only the highest
priority traffic is sent at priority 3 through the switch.
PR 60599
The watch dog does not reboot the switch when the OS7000 locks up, due to a corrupt image file.
Workaround: Power cycle the switch and FTP a new version of the software, if possible.
PR 60636
Fully qualified instances in "systemMicrocodeDependencyTable" return a NoSuchInstance error on an
OS7000 series switch. Only SNMP GetNext requests work on the entire table, but SNMP get for specific
instances fails.
Workaround: The user must use snmpget on table to read items.
PR 60675
The mac-range command does not update the routing information upon completion.
Workaround: For the mac-range command to take effect (have the chassis use the new macs), the chas-
sis needs to be rebooted. In fact, when the first mac-range changes, the switch must reboot. All VLAN and
routing functionalities beyond that point is not be supported.
PR 61018
While modifying the boot parameters on an OS7000 series switch, an input of “.” for an IP address is
interpreted as an IP address of 0.0.0.0.
Workaround: There is no known workaround at this time.
PR 61534
The FTP session has problems connecting to a switch, while the certify process is still running.
Workaround: Do not attempt to FTP files to/from switch while the certify process is still running.
PR 61572
When the protocol reference is not specified in the Ethernet frame, layer 2 traffic is not accepted on an
OS7000 series switch.
Workaround: There is no known workaround at this time.