Specifications

34 SMS 7000 Release Notes
Version 6.41
Flash Memory Limitations and Recovery Procedure
If file space is not available on the target MCPU flash file system, the PC
monitor may display the following error:
---> PORT (etc.)
---> STOR file.name (which failed to load to the MCPU
file system)
netout: Socket is not connected
Error in input file
---> QUIT
C:\SMS7000>
Note It will save much aggravation if you take care not to run out of
flash memory. Check for available space (using the dir com-
mand at the diagnostic terminal) before and after loading soft-
ware into the router. If it reports 0 bytes of available memory, you
will need to perform the
Flash Memory Limitations and Recov-
ery Procedure
on page 34 (reformatting flash memory) to re-
claim use of all sectors of flash memory:
Make sure your router configuration is saved on the GUI PC.
Save (or write down the contents of) the following files in flash:
(copy “thefilename” 0 will show the file contents)
the “gateways” file, if any
any.ini file other than boot.ini, eventlog.ini or console.ini
Reformat Flash Memory:
Start a Reboot
C:\sms7000> Reboot
from the Diagnostic Terminal) then hit a key to stop the boot pro-
cess.
C:\SMS7000 Boot> F
(then y, please reformat flash) to reformat 2047 sectors with no er-
rors. The next 2 lines resave boot.ini to flash memory:
C:\SMS7000 Boot> c
C:\ SMS7000 Boot> ctrl-D
Restore saved files:
Use the GUI to send the config to the MCPU & to save it in Nonvol-
atile(flash) Memory. The other saved files can be ftp'd to the router,
or you can recreate the file in flash memory by typing:
copy 0 “thefilename”
type first line here
type second line here etc.
then to verify it, type:
C:\sms7000. copy “thefilename” 0
Reload MCPU software using the “R64load” command at the PC