user manual

4 – Network and Fabric Configuration
Configuring the Ethernet Port
4-4 59183-01 A
S
4.3
Configuring the Ethernet Port
Configure the switch Ethernet port using the Set Setup System command within
an Admin session. The following example configures a new IP address, subnet
mask, and gateway address.
SANbox (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ]
EthNetworkAddress (dot-notated IP Address) [10.0.0.1 ] 10.20.30.40
EthNetworkMask (dot-notated IP Address) [255.255.255.0] 255.0.0.0
EthGatewayAddress (dot-notated IP Address) [10.0.0.254 ] 10.20.30.254
AdminTimeout (dec value 0-1440 minutes, 0=never) [30 ]
InactivityTimeout (dec value 0-1440 minutes, 0=never) [0 ]
LocalLogEnabled (True / False) [True ]
RemoteLogEnabled (True / False) [False ]
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254 ]
NTPClientEnabled (True / False) [False ]
NTPServerAddress (dot-notated IP Address) [10.0.0.254 ]
EmbeddedGUIEnabled (True / False) [True ]
Do you want to save and activate this system setup? (y/n): [n] y